Paradyne 3163 - Manual (Page 135)

Asynchronous Terminal Interface Operation
G-13 3163-A2-GB20-10 March 1999
Configuration Worksheets for
the ATI
This section contains one set of blank worksheets to be
used when configuring your DSU/CSU using the ATI. In
the tables, default settings for Default Factory 1 are
indicated by bold type. It is recommended that you copy
these blank worksheets before using them.
Network Interface Options
Front Panel
Equivalent
Value (Default in Bold)
Line Framing Format NET Framing D4, ESF
Line Coding Format NET Coding AMI, B8ZS
Line Build Out (LBO) LBO 0.0, –7.5, –15, –22.5
Management Link Mgmt Link Enable, Disable
Bit Stuffing BitStuff 62411, Part68, Disable
Network Initiated LLB NET LLB Enable, Disable
Network Initiated PLB NET PLB Enable, Disable
ANSI Performance Report Messages ANSI PRM Enable, Disable
Circuit Identifier Circuit Ident Text Field, Clear
DTE Interface Options
Front Panel
Equivalent
Value (Default in Bold)
Interface Status DTE Port Enable, Disable
Line Framing Format DTE Framing D4, ESF
Line Coding Format DTE Coding AMI, B8ZS
Line Equalization Equal 0 –133, 133 –266, 266 –399, 399 –533,
533 –655
DTE LB on External Contact Extrn DLB Enable, Disable
Send All Ones on DTE Failure Send Ones Enable, Disable