Paradyne 3163 - Manual (Page 37)

Operation
3-15 3163-A2-GB20-10 March 1999
Configuring DS0 Channels
The DSU/CSU provides channel configuration options
that allow you to do the following:
•
Display the DS0 assignments for the network and
data port interfaces.
•
Allocate DS0 channels on the network interface to
the data port.
•
Clear (deallocate) all DS0 channels from the
network or data port interface.
To allocate DS0 channels, begin by defining the logical
channel configuration for the network interface, and then
Port 1, if desired.
Blank configuration worksheets are provided at the
back of Appendix C, Configuration Options . To complete
the configuration worksheets for DS0 channel allocation:
1. Using the worksheet shown in Figure 3-6, circle
the configuration options needed to implement the
logical channel configuration.
2. Once you have completed the worksheet, enter
this information using the procedures in the
Allocating Data Ports section on page 3-17.
Port Chan
Conf
Options Value
Assign To NET
Assign By Block, ACAMI, Chan
If Assign By Block
Port Rate Nx64: 64, 128, 192, 256, 320, 384, 448, 512, 576,
640, 704, 768, 832, 896, 960, 1024, 1088, 1152,
1216, 1280, 1344, 1408, 1472, 1536
Nx56: 56, 112, 168, 224, 280, 336, 392, 448, 504,
560, 616, 672, 728, 784, 840, 896, 952, 1008, 1064,
1120, 1176, 1232, 1288, 1344
Port 1
Start At Time Slot (N x): 1, 2, 3, 4, 5, 6, 7, 8, 9, 10, 11, 12, 13,
14, 15, 16, 17, 18, 19, 20, 21, 22, 23, 24
(Select One)
If Assign By
ACAMI
Port Rate Nx64: 64, 128, 192, 256, 320, 384, 448, 512, 576,
640, 704, 768
Nx56: 56, 112, 168, 224, 280, 336, 392, 448, 504,
560, 616, 672
ACAMI
Start At Time Slot (N x ): 1, 2, 3, 4, 5, 6, 7, 8, 9, 10, 11, 12, 13,
14, 15, 16, 17, 18, 19, 20, 21, 22, 23
(Select One)
If Assign By Chan Time Slot (N x): 1, 2, 3, 4, 5, 6, 7, 8, 9, 10, 11, 12, 13,
14, 15, 16, 17, 18, 19, 20, 21, 22, 23, 24
(Select Multiple)
Figure 3-6. Port Channel Configuration Worksheet