Philips HEARTSTART XLT M3500B - Manual (Page 141)

System Messages
M3500B HeartStart XLT Defibrillator/Monitor 12-5
12
Momentary Messages
Momentary messages are temporary and only appear on the display for a few
seconds. Each message is accompanied by a three second beep to alert you.
Table 12-2 lists momentary messages.
Table 12-2 Momentary Messages
Message Possible Cause Corrective Action
$WWDFK 3DGV
The multifunction defib electrode pads
are not making proper contact with the
patient. z Check the pads are applied to the
patient, as directed on the pads’ pack-
age.
z Replace the pads if the prompt contin-
ues.
$WWDFK /HDGV
An attempt was made to begin pacing in
Demand Mode without ECG leads
attached to the patient. Attach leads to patient.
'HILE 'LVDUPHG
z The pads connection is compromised.
z The mode is changed from Manual to
AED while the defibrillator is
charged.
z is not pressed within 30 sec-
onds of the defibrillator being
charged.
z is pressed.
z Check the pads are applied to the
patient properly.
z If a shock is indicated, deliver the
shock before changing modes.
z To deliver a shock, press
within 30 seconds of the defibrillator
being charged.
1R 6KRFN 'HOLYHUHG
Patient impedance is too high. z Make sure the pads are applied prop-
erly.
z Replace the pads, if necessary
&KHFN 3ULQWHU
Printer paper is absent or jammed; the
printer door is not closed properly. z Reload printer paper.
z Make sure the door is closed properly.
6+2&.
',6$50
6+2&.