Philips HEARTSTART XLT M3500B - Manual (Page 114)

Configuring the HeartStart XLT
10-16 Setting Up and Configuring the HeartStart XLT
Saving Settings to a Data Card
Configuration settings may be saved to a Data Card and used to load the same
configuration into other HeartStart XLTs or to restore the configuration, if
necessary.
To save the configuration:
1. Make sure a Data Card is in the HeartStart XLT before turning the unit on.
2. Select 6DYH 6HWWLQJV WR 'DWD &DUG from the main configuration menu.
3. Press in response to the question
6DYH 6HWWLQJV WR 'DWD &DUG"
.
The HeartStart XLT saves the configuration settings to the Data Card and
returns to the main configuration menu.
Loading Settings from a Data Card
To load configuration settings:
1. Make sure a Data Card is in the HeartStart XLT.
2. Select /RDG 6HWWLQJV IURP 'DWD &DUG from the main configuration menu.
3. Press in response to the question /RDG 6HWWLQJV IURP 'DWD &DUG" .
The HeartStart XLT loads the configuration settings from the Data Card and
returns to the main configuration menu.
Printing Settings
To print the configuration settings, select 3ULQW $OO 6HWWLQJV from the main config-
uration menu.
6$9(
/2$'