Lexmark 5300 - Manual (Page 149)

8 Press .
9 Press or repeatedly to view the current Fax Forwarding setting.
10 To turn off Fax Forwarding, press or repeatedly until Off appears.
11 Press to save the setting.
Can receive but not send faxes
These are possible causes and solutions. Try one or more of the following:
C
HECK MODE SELECTION
To make sure the printer is set for faxing, press Fax Mode.
C
HECK DOCUMENT PLACEMENT
Load the original document in the upper left corner of the scanner glass.
C
HECK THE
D
IAL
P
REFIX SETTING
1 From the control panel, press Fax Mode.
2 Press .
3 Press or repeatedly until Fax Setup appears.
4 Press .
5 Press or repeatedly until Dialing and Sending appears.
6 Press .
7 Press or repeatedly until Dial Prefix appears.
8 Press .
9 To change the setting, press or repeatedly until Create appears.
10 Press .
11 Enter the prefix to be dialed before each telephone number.
12 Press .
C
HECK
S
PEED
D
IAL NUMBER
• Check to make sure Speed Dial has been programmed for the number that you want to dial. See “Setting up
Speed Dial using the computer” on page 57.
• You can also dial the telephone number manually.
Troubleshooting
149