Lexmark 5300 - Manual (Page 148)

I
S YOUR PRINTER MEMORY FULL
?
Change the setting to Scan after Dial.
1 From the control panel, press Fax Mode.
2 Press .
3 Press or repeatedly until Fax Setup appears.
4 Press .
5 Press or repeatedly until Dialing and Sending appears.
6 Press .
7 Press or repeatedly until Scan appears.
8 Press .
9 Press or repeatedly until After Dial appears.
10 Press .
Can send but not receive faxes
These are possible causes and solutions. Try one or more of the following:
L
OAD PAPER
Load paper to print any faxes that have been stored in the printer.
C
HECK THE
A
UTO
A
NSWER BUTTON
If the Auto Answer light is on:
• The printer will answer after the preset number of telephone rings.
• If you are using a distinctive ring, see “Setting the distinctive ring” on page 59.
C
HECK INK
Check the ink levels, and install a new cartridge if necessary.
C
HECK WHETHER
F
AX
F
ORWARDING IS SELECTED
1 From the control panel, press Fax Mode.
2 Press .
3 Press or repeatedly until Fax Setup appears.
4 Press .
5 Press or repeatedly until Ringing and Answering appears.
6 Press .
7 Press or repeatedly until Fax Forward appears.
Troubleshooting
148