Lexmark 5300 - Manual (Page 126)

D
ISCONNECT AND RECONNECT THE POWER CORD
1 Disconnect the power cord from the wall outlet, and then from the printer.
2 Plug the cord all the way into the power supply on the printer.
3 Plug the cord into an electrical outlet that other electrical devices have been using.
4 If the light is not on, press .
Software does not install
These are possible causes and solutions. Try one or more of the following:
C
HECK YOUR OPERATING SYSTEM
The following operating systems are supported:
• Windows 2000
• Windows XP
• Windows Vista
• Mac OS X
C
HECK YOUR SYSTEM REQUIREMENTS
Check that your computer meets the minimum system requirements listed in the box.
C
HECK YOUR
USB
CONNECTION
1 Check the USB cable for any obvious damage.
2 Firmly plug the square end of the USB cable into the back of the printer.
3 Firmly plug the rectangular end of the USB cable into the USB port of the computer.
The USB port is marked with the USB symbol.
R
ECONNECT THE POWER SUPPLY
1 Press to turn the printer off.
2 Disconnect the power cord from the wall outlet.
3 Gently remove the power supply from the printer.
4 Reconnect the power supply to the printer.
Troubleshooting
126