Lenovo RD210 User Manual
Installation and user guide
This manual is related to the following products:
Table of contents
Document Outline
- Contents
- Safety
- Chapter 1. Introduction
- Chapter 2. Server setup roadmap
- Chapter 3. What is included with your server
- Chapter 4. Server controls, LEDs, and power
- Chapter 5. Installing optional devices and replacing customer replaceable units
- Installation guidelines
- Major components of the server
- Removing and replacing the cover
- Internal cable routing and connectors
- Removing and installing the microprocessor 2 air baffle
- Removing and installing the DIMM air baffle
- Removing and installing a hot-swap hard disk drive
- Removing and installing a PCI riser-card assembly
- Removing and installing an adapter
- Removing and installing a memory module (DIMMs)
- Removing and installing the IBM ServeRAID-BR10i SAS/SATA Controller
- Removing and installing the optional IBM ServeRAID-MR10i SAS/SATA Controller
- Removing and installing a microprocessor and heat sink
- Removing and installing a hot-swap power supply
- Removing and installing a hot-swap fan assembly
- Removing and installing the SAS/SATA RAID riser-card assembly
- Removing and installing the battery
- Removing and installing the PCI riser-card assembly
- Removing and installing the hot-swap SAS/SATA hard disk drive backplane
- Removing and installing the operator information panel assembly
- Removing and installing the system board
- Removing and installing a CD/DVD drive
- Removing and installing the virtual media key
- Removing and installing the optional two-port Ethernet adapter
- Removing and installing the PCI riser-card bracket from the riser card
- Removing and installing a remotely installed RAID adapter battery
- Removing and installing the bezel
- Removing and installing the operator information panel assembly
- Completing the installation
- Chapter 6. Configuring the server
- Using the Setup Utility
- Using the Boot Manager program
- Configuring RAID controllers
- Using the WebBIOS utility
- Using the EasyStartup DVD
- Enabling the Broadcom Gigabit Ethernet Utility program
- Updating the firmware
- Using the EasyUpdate Firmware Updater tool
- Starting the backup server firmware
- Recovering the UEFI firmware
- Using the integrated management module
- IBM Advanced Settings Utility program
- Installing ThinkServer EasyManage software
- Using the remote presence capability and blue-screen capture
- Configuring the Gigabit Ethernet controllers
- Chapter 7. Solving problems
- Diagnostic tools
- POST
- Troubleshooting tables
- EasyStartup problems
- CD/DVD drive problems
- General problems
- Hard disk drive problems
- Intermittent problems
- Keyboard, mouse, or pointing-device problems
- Memory problems
- Microprocessor problems
- Monitor problems
- Optional-device problems
- Power problems
- Serial-device problems
- Software problems
- Universal Serial Bus (USB) port problems
- Video problems
- EasyLED
- Diagnostic programs and messages
- Power-supply diagnostics
- Appendix A. Getting help and technical assistance
- Appendix B. Notices
- Trademarks
- Important notes
- Compliance with Republic of Turkey Directive on the Restriction of Hazardous Substances
- Product recycling and disposal
- Battery return program
- German Ordinance for Work gloss statement
- Electronic emissions notices
- Federal Communications Commission (FCC) statement
- Industry Canada Class A emission compliance statement
- Avis de conformité à la réglementation dIndustrie Canada
- Australia and New Zealand Class A statement
- United Kingdom telecommunications safety requirement
- European Union EMC Directive conformance statement
- German Class A compliance statement
- Japanese Voluntary Control Council for Interference (VCCI) statement
- Japanese recycling statements
- Taiwanese Class A warning statement
- Chinese Class A warning statement
- Korean Class A warning statement
- Index