Lenovo RD210 - Manual (Page 117)

1. Read the safety information in “Safety” on page vii and “Installation guidelines”
on page 39.
2. Remove the cover (see “Removing and replacing the cover” on page 43).
3. Align the virtual media key with the mounting tab and slide it down the tab onto
the connector on the system board. Press the virtual media key down into the
connector until it is firmly seated on the system board.
1 Virtual media key (front)
2 Mounting bracket (rear)
3 Mounting tab
4 Virtual media key connector
4. Replace the cover (see “Removing and replacing the cover” on page 43).
5. Slide the server into the rack.
6. Reconnect the power cord and any cables that you removed.
7. Turn on the peripheral devices and the server.
Removing and installing the optional two-port Ethernet adapter
To remove and install the optional two-port Ethernet adapter, complete the steps in
this section.
Removing the optional two-port Ethernet adapter
To remove the optional two-port Ethernet adapter, complete the following steps:
1. Read the safety information in “Safety” on page vii and “Installation guidelines”
on page 39.
2. Turn off the server and peripheral devices and disconnect all power cords.
3. Remove the cover (see “Removing and replacing the cover” on page 43).
Chapter 5. Installing optional devices and replacing customer replaceable units 101