Lenovo RD210 - Manual (Page 105)

1 Backplane tabs
2 Hard disk drive backplane
3 Backplane tabs
4 Backplane bracket slots
7. Install the cover (see “Removing and replacing the cover” on page 43).
8. Replace the hard disk drives.
9. Slide the server into the rack.
10. Reconnect the power cords and any cables that were removed.
11. Turn on the peripheral devices and the server.
Removing and installing the operator information panel assembly
To remove and install the operator information panel assembly, complete the steps
in this section.
Removing the operator information panel assembly
To remove the operator information panel, complete the following steps.
1. Read the safety information in “Safety” on page vii and “Installation guidelines”
on page 39.
2. Turn off the server and peripheral devices and disconnect all power cords; then,
remove the cover (see “Removing and replacing the cover” on page 43).
3. Disconnect the cable from the back of the operator information panel assembly
1 .
4. Push the blue release latch 2 to the left until it unlatches.
5. Reach inside the server and push the assembly toward the front of the server.
Chapter 5. Installing optional devices and replacing customer replaceable units 89