Installing a hot-swap power supply, Installing, Hot-swap – Lenovo RD210 User Manual
Page 94: Power, Supply
5.
If
you
are
instructed
to
return
the
power
supply,
follow
all
packaging
instructions,
and
use
any
packaging
materials
for
shipping
that
are
supplied
to
you.
6.
If
you
are
replacing
a
defective
power
supply,
continue
to
Installing
a
hot-swap
power
supply
The
following
notes
describe
the
type
of
power
supply
that
the
server
supports
and
other
information
that
you
must
consider
when
installing
a
power
supply:
To
install
a
hot-swap
power
supply,
complete
the
following
steps:
1.
Read
the
safety
information
in
and
2.
Touch
the
static-protective
package
that
contains
the
hot-swap
power
supply
2
to
any
unpainted
metal
surface
on
the
server;
then,
remove
the
power
supply
2
from
the
package
and
place
it
on
a
static-protective
surface.
3.
If
you
are
installing
a
hot-swap
power
supply
into
an
empty
bay,
remove
the
power-supply
filler
panel
3
from
the
power-supply
bay.
4.
Grasp
the
handle
on
the
rear
of
the
power
supply
and
slide
the
power
supply
forward
into
the
power-supply
bay
until
it
clicks.
Make
sure
that
the
power
supply
connects
firmly
into
the
power-supply
backplane.
78
ThinkServer
RD210
Types
3795,
3796,
3818,
and
3819:
Installation
and
User
Guide