Replacing the cover, Internal cable routing and connectors, Replacing – Lenovo RD210 User Manual
Page 60: Cover, Internal, Cable, Routing, Connectors
3.
If
the
server
has
been
installed
in
a
rack,
slide
the
server
out
from
the
rack
enclosure.
See
the
Rack
Installation
Instructions
that
come
with
the
server
for
information
about
removing
the
server
from
the
rack.
4.
Press
down
firmly
on
the
two
blue
tabs
on
the
top
(near
the
front
of
the
server)
of
the
cover
and
slide
the
cover
toward
the
rear
of
the
server
until
the
cover
has
disengaged
from
the
chassis.
5.
Lift
the
server
cover
off
the
server
and
set
it
aside.
Replacing
the
cover
Attention:
For
proper
cooling
and
airflow,
replace
the
server
cover
before
you
turn
on
the
server.
To
replace
the
server
cover,
complete
the
following
steps:
1.
Align
the
cover
1
over
the
server
(toward
the
rear
of
the
server)
until
the
cover
edges
slip
in
position
over
the
chassis.
2.
Press
down
on
the
two
blue
tabs
2
and
3
on
the
front
of
the
cover,
while
sliding
the
cover
forward
toward
the
front
of
the
server
until
the
cover
is
completely
closed.
Internal
cable
routing
and
connectors
The
following
illustration
shows
the
internal
routing
and
connectors
for
the
two
SAS
signal
cables
(in
server
models
with
eight
SAS
drive
bays).
Notes:
1.
To
connect
the
SAS
signal
cables,
make
sure
that
you
first
connect
the
signal
cable,
and
then
the
power
cable
and
signal
cable.
2.
To
disconnect
the
SAS
signal
cables,
make
sure
that
you
first
disconnect
the
power
cable,
and
then
the
signal
cable
and
configuration
cable.
44
ThinkServer
RD210
Types
3795,
3796,
3818,
and
3819:
Installation
and
User
Guide