Lenovo RD210 - Manual (Page 110)

7. Reinstall the DIMMs (see “Removing and installing the DIMM air baffle” on
page 48).
8. Reinstall the microprocessor 2 and DIMM air baffles (see “Removing and
installing the microprocessor 2 air baffle” on page 47 and “Removing and
installing the DIMM air baffle” on page 48).
9. Reinstall the PCI riser-card assemblies and adapters, if any were installed (see
“Removing and installing the SAS/SATA RAID riser-card assembly” on page
82).
10. Reinstall IMM Premium (see “Removing and installing the virtual media key” on
page 100).
11. Reconnect to the system board the cables that you disconnected.
12. Install the cover (see “Removing and replacing the cover” on page 43).
13. Slide the server into the rack.
14. Reconnect the power cords and any cables that you removed.
15. Turn on the peripheral devices and the server.
Important: Perform the following updates:
v Either update the server with the latest RAID firmware or restore the pre-existing
firmware from a diskette or CD image.
v Update the UUID.
v Update the DMI/SMBIOS.
Removing and installing a CD/DVD drive
To remove and install a CD/DVD drive, complete the steps in this section.
Removing a CD/DVD drive
To remove a CD/DVD drive, complete the following steps:
1. Read the safety information in “Safety” on page vii and “Installation guidelines”
on page 39.
2. Turn off the server and peripheral devices and disconnect all power cords.
3. Remove the cover (see “Removing and replacing the cover” on page 43).
4. Press and hold the release tab 1 down as you push the drive 2 from the
rear to slide it out of the bay.
94 ThinkServer RD210 Types 3795, 3796, 3818, and 3819: Installation and User Guide