Removing the pci riser-card assembly, Installing the pci riser-card assembly, Removing – Lenovo RD210 User Manual
Page 102: Riser-card, Assembly, Installing
Removing
the
PCI
riser-card
assembly
To
remove
a
PCI
riser-card
assembly,
complete
the
following
steps:
1.
Read
the
safety
information
in
and
2.
Turn
off
the
server
and
peripheral
devices
and
disconnect
the
power
cords
and
all
external
cables.
Note:
When
you
disconnect
the
power
source
from
the
server,
you
will
lose
the
ability
to
view
the
LEDs
because
the
LEDs
will
not
be
lit
with
the
power
source
removed.
Before
disconnecting
the
power
source,
make
a
note
of
which
LEDs
are
lit,
including
the
LEDs
that
are
lit
on
the
operation
information
panel,
the
EasyLED
panel,
and
LEDs
that
are
lit
inside
the
server
on
the
system
board;
then,
see
for
information
on
how
to
solve
the
problem.
3.
Remove
the
cover
(see
4.
If
an
adapter
is
installed
in
the
riser-card
assembly,
disconnect
any
cables
that
are
connected
to
the
adapter.
5.
Grasp
the
rear
of
the
riser-card
assembly
from
the
rear
and
lift
it
out
of
the
PCI
riser-card
slot
on
the
system
board.
1
PCI
riser-card
assembly
(full-height,
full-length
adapters)
2
PCI
riser-card
assembly
(low-profile
adapters)
3
PCI
riser
connector
1
4
PCI
riser
connector
2
6.
Remove
the
adapter,
if
one
is
present,
from
the
riser-card
assembly.
7.
Set
the
adapter
and
riser-card
assembly
aside.
Installing
the
PCI
riser-card
assembly
To
replace
a
PCI
riser-card
assembly,
complete
the
following
steps:
1.
Read
the
safety
information
in
and
86
ThinkServer
RD210
Types
3795,
3796,
3818,
and
3819:
Installation
and
User
Guide