Siemens Industrial Ethernet Switches SCALANCE X-200 - Manual (Page 206)

Configuration / diagnostics using remote mechanisms
6.3 Configuration using Web Based Management (WBM) and Command Line Interface (CLI)
SCALANCE X-200
206
Operating Instructions, 12/2011, A5E00349864-19
Syntax of the Command Line Interface
Table 6- 20 Agent Event Configuration - CLI\AGENT\EVENT>
Command Description Comment
info Shows the current event configuration.
scontrol [C|A]. Selects how the signaling contact works:

Conventional
An error/fault is displayed by the LED and
the signaling contact opens.
 Aligned
The signaling contact can be opened or
closed as required regardless of a
fault/error.
Administrator only.
sclose [yes|no] Switches the signaling contact, if this in
"aligned" mode:

Yes
The contact is closed.
 No:
The contact is opened
Administrator only.
Specifies how an IE switch reacts to system
events. You can enter the following values for
the parameter:
CW
Cold/Warm Start
LC Link Change
AF Authentication
Failure
PM Power M12
Change
FC Fault State Change
RD Redundancy Event
SB Standby Event
setec
LD Loop Detection
Administrator only.
If an event is specified, the configured
actions are formed for each event.
The three parameters or configure
the reactions of the IE switch in the order:

E-mail
 Trap
 Entry in the log table
Example: If you only want to send an E-mail
when there is a Link Change, enter the
following command:
setec LC E D D