Siemens Industrial Ethernet Switches SCALANCE X-200 - Manual (Page 153)

Configuration / diagnostics using remote mechanisms
6.1 Assignment of an IP address
SCALANCE X-200
Operating Instructions, 12/2011, A5E00349864-19
153
tarting Web Based Management
mponent) such as the X-200 IE switches have a Web
ice you want to configure with Web Based Management
with four blue cords).
S
INC devices (Industrial Network Co
Based Management. Select the dev
and perform one of the following steps to start Web Based Management:
● Select the Module > INC Browser menu command.
● Click on the third button from the left in the toolbar (module
Figure 6-4 Dialog for starting Web Based Management
n are deactivated, there is no Web
Based Management for the selected module.
Removing a module
can remove a module from the list in the left part of the program window by selecting the
ule > Remove Module menu command. Using this menu has no effect on the existence
Assigning a PN IO device name
PN IO device name to PROFINET IO-compliant devices. After selecting
ign Name menu, a dialog box opens in which you can enter the required
Finding the location of a device
"Flash" command, you can make the LEDs of the relevant device flash.
is menu, a dialog appears with which you can start and finish signaling.
If the Module > Start INC Browser and the module ico
You
Mod
of a module in the network, after browsing the network again, all modules would be
displayed again.
You can assign a
the Module > Ass
name. The name can be a maximum of 255 characters long and over and above letters and
numbers can contain only the special characters slash, hyphen, and underscore. The first
character must be a letter.
With the Module
After selecting th
The activity of the LEDs indicates which device is assigned to a particular list entry in the
program window.