Siemens Industrial Ethernet Switches SCALANCE X-200 - Manual (Page 176)

Configuration / diagnostics using remote mechanisms
6.3 Configuration using Web Based Management (WBM) and Command Line Interface (CLI)
SCALANCE X-200
176
Operating Instructions, 12/2011, A5E00349864-19
System Command Line Interface
Table 6- 6 System Save & Load TFTP - CLI\SYSTEM\LOADSAVE>
Command Description Comment
info Displays information on the
system.
server [IP address] [:port] Specifies the IP address or the
port of the TFTP server with
which data will be exchanged.
Administrator only.
fwname Specifies the name of the
firmware file.
Administrator only.
fwload Loads the firmware from a file. Administrator only.
fwsave Saves the firmware in a file. Administrator only.
cfgname [file name] Specifies the name of a file
(maximum 255 characters) from
which the configuration data will
be loaded or in which this data
will be saved.
Administrator only.
cfgsave Saves the configuration data in
a file.
Administrator only.
cfgload Loads the configuration data
from a file.
Administrator only.
logname [file name] Specifies the name of a file
(maximum 255 characters) in
which the log table is stored.
Administrator only.
logsave Saves the log table in a file.
pkname Specifies the name of the file
(maximum 255 characters) that
contains the private SSL key.
Administrator only.
pkload Loads the private SSL key from
a file.
Administrator only.
ctname Specifies the name of the file
(maximum 255 characters) that
contains the SSL certificate.
Administrator only.
ctload Loads the SSL certificate from a
file.
Administrator only.