Sharp MX-7001 - Manual (Page 99)

18
3
Set the number of copies (number of
sets) with the numeric keys.
• Up to 999 copies (sets) can be set.
• A single copy can be made even if "0" appears for the number of copies.
If an incorrect number of copies is set...
Press the [CLEAR] key (
) and then enter the correct number.
4
Press the [COLOR START] key ( )
or the [BLACK & WHITE START] key
(
).
Normally copying will start.
Depending on the copy settings (2-sided copying, etc.), copying
may not begin until all originals have been scanned. In this
case, go to the next step.
Even if a color mode is selected, copying will take place in black and white if the [BLACK & WHITE START] key ( )
is pressed.
5
Remove the original and place the next
original, and then press the [COLOR
START] key (
) or the [BLACK &
WHITE START] key ( ).
Repeat this step until all originals have been scanned.
For the second original and following originals, use the same
[START] key as you did for the first original.
6
Touch the [Read-End] key.
To cancel scanning of the original and copying...
Press the [STOP] key (
).
7
Plain
8½x11
Special Modes
2-Sided Copy
or
or
Read-End
Place next original. Press [Start].
When finished, press [Read-End].