Sharp MX-7001 - Manual (Page 14)

14
SYSTEM BAR
The system bar appears at the bottom of the touch panel.
The items that appear in the system bar are explained below.
(1) Job status display
The first four jobs in progress or reserved are indicated
by icons. The icons are as follows.
The status of the first job is indicated as shown in (A).
The color appearing in the job status display depends on
the job status as indicated in the table below.
The job status display can be touched to show the job
status screen.
(2) USB device display
This appears when a USB memory or other USB device
is connected to the machine.
(3) Brightness adjustment key
Touch this key to adjust the brightness of the touch
panel.
When touched, the following screen appears next to the
key.
Touch the [+] key or the [-] key to adjust the brightness.
When finished, touch the brightness adjustment key
again to close the screen.
Color Mode Special Modes
Plain
2-Sided Copy
Output
File
Quick File
Copy Ratio
Printing
100%
11x17 3.
1. 2.
8½x11 8½x11
Original Paper Select
Auto
8½x11
Plain
Auto
8½x11
Full Color
Exposure
Auto
8½x14 4.
8½x11
(2) (3) (A) (1)
Print job Copy job
Scan to E-mail
job Scan to FTP job
Scan to
Network Folder
job Scan to
Desktop job
Fax
transmission
job Fax reception
job
PC-Fax
transmission
job Internet fax
transmission
job
Internet Fax
reception job PC-I-Fax
transmission
job
Broadcast job Scan to HDD
file print job
Tandem
copy/print job
Job status
display
Machine Configuration
Green
A print, scan or other job is being
executed normally.
Yellow
The machine is warming up or on
standby, or a job is being canceled.
Red
A paper misfeed or other error
condition has occurred.
Gray The machine has no jobs.