Sharp MX-7001 - Manual (Page 43)

43
Fusing unit pressure adjusting levers
It may happen that creases, color deviations, or smudging may occur even when envelopes within the specifications are
used. This problem can be alleviated by shifting the fusing unit pressure adjusting levers from the regular pressure
position to the low pressure position. To shift the fusing unit pressure adjusting levers, follow the steps below.
1
Pull out the right side cover.
While pushing up the right side cover release lever, gently open
the cover.
2
Move the fusing unit pressure adjusting
levers (two) to the low pressure position
as shown.
Caution
The fusing unit is hot. Take care not to burn yourself when operating the fusing unit pressure adjusting levers.
Be sure to return the levers to the regular position when you have finished feeding envelopes. Otherwise, inadequate
toner adherence, paper misfeeds, and other problems may occur.
3
Gently close the right side cover.
A
B
Regular
position
Low pressure position
A: Front side of
fusing unit
B: Rear side of
fusing unit