Interior, Caution – Sharp MX-7001 User Manual
Page 7
7
INTERIOR
(16) Paper pass unit*
This transfers output to the finisher or saddle stitch
finisher.
(17) Toner cartridges
These contain toner for printing. When the toner runs out
in a cartridge, the cartridge of the color that ran out must
be replaced.
☞
REPLACING THE TONER CARTRIDGES
(page 74)
(18) Fusing unit
Heat is applied here to fuse the transferred image onto
the paper.
(19) Transfer belt
During full color printing, the toner images of each of the
four colors on each of the photoconductive drums are
combined together on the transfer belt. During black and
white printing, only the black toner image is transferred
onto the transfer belt.
(20) Right side cover
Open this cover to operate the fusing unit pressure
adjusting lever and to remove a misfeed.
☞
Fusing unit pressure adjusting levers
(21) Paper reversing section cover
This is used when 2-sided printing is performed. Open
this cover to remove a paper misfeed.
(22) Bypass tray
Use this tray to feed paper manually.
When loading paper larger than 8-1/2" x 11"R or A4R, be
sure to pull out the bypass tray extension.
☞
LOADING PAPER IN THE BYPASS TRAY
(23) Main power switch
This is used to power on the machine.
When using the fax or Internet fax functions, keep this
switch in the "on" position.
☞
(page 16)
(24) Waste toner box
This collects excess toner that remains after printing.
☞
(25) Waste toner box compartment cover
Open this to remove a paper misfeed from trays 1 to 4, or
to replace the waste toner box.
(26) Right side cover release lever
To remove a paper misfeed, pull and hold this lever up to
open the right side cover.
* Peripheral device.
(22)
(21)
(19) (20)
(18)
(16)
(17)
(25)
(26)
(24)
(23)
When a finisher /
saddle stitch finisher is
not installed
Caution
The fusing unit is hot. Take care not to burn yourself
when removing a paper misfeed.
Do not touch or damage the transfer belt. This may
cause a defective image.
Your service technician will collect the waste toner
box.