Sharp MX-7001 - Manual (Page 130)

49
ERASING PERIPHERAL SHADOWS (Erase)
The erase function is used to erase shadows around the edges of copies that occur when copying thick originals or
books.
When a thick book is copied
Erase modes
Shadows appear here
Not using the erase
function
Using the erase
function
Shadows appear on the
copy. Shadows do not appear on
the copy.
1
Place the original.
Place the original face up in the document feeder tray, or face down on the document glass.
2
Select the special modes.
(1) Touch the [Special Modes] key.
(2) Touch the [Erase] key.
☞
Special modes menu (1st screen) (page 44)
3
Select the erase settings.
(1) Touch the desired erase mode.
Select one of the three positions.
(2) Set the erasure width with .
0" to 1" (0 mm to 20 mm) can be entered.
(3) Touch the [OK] key.
You will return to the base screen of copy mode.
Edge Erase Center Erase Edge + Center Erase
Special Modes OK
1/2
Erase
Edge
Erase Edge
(0~1)
inch
1/2
Center
(0~1)
inch
OK Cancel
Center
Erase
Edge+Center
Erase
(2) (3) (1)