Sharp MX-7001 - Manual (Page 101)

20
Using the [Binding Change] key
4
Check the paper to be used and the
color mode.
Make sure that the desired paper (tray) and color mode are
selected.
• To change the paper (tray), touch the [Paper Select] key.
☞
PAPER TRAYS (page 14)
• To change the color mode, touch the [Color Mode] key.
☞
COPY COLOR MODES (page 24)
Depending on the size of the placed original, there may be cases where the same size of paper as the original is not
selected automatically. In this event, change the paper size manually.
5
Set the number of copies (number of
sets) with the numeric keys.
• Up to 999 copies (sets) can be set.
• If you are only making a single copy, the copy can be made with the copy number display showing "0".
If an incorrect number of copies is set...
Press the [CLEAR] key (
) and then enter the correct number.
6
Press the [COLOR START] key ( ) or
the [BLACK & WHITE START] key ( ).
To cancel scanning of the original and copying...
Press the [STOP] key (
).
Originals Binding Change is used Binding Change is not used
The reverse side
is upside down. The reverse side
is not upside
down.
Select this when
the pages will be
bound into a
tablet. Select this when
the pages will be
bound into a
booklet.
Color Mode Special Modes
Plain
2-Sided Copy
Output
File
Quick File
Copy Ratio
100%
11x17 3.
1. 2.
8½x11 8½x11
Original Paper Select
Auto
8½x11
Plain
Auto
8½x11
Full Color
Exposure
Auto
8½x14 4.
8½x11
7
Plain
8½x11
Special Modes
2-Sided Copy
or
A
1 2
A A
A
3
A