Siemens Gigaset 2010 - Manual (Page 43)

Base station settings
33
KAP09.FM5 14.8.98 Gigaset 2010, UEB/engl.: A30852-X1100-E301-2-7619
Setting the base station ringer tone
It is possible to define the tone used to signal calls at the
base station. You can choose from a range of six tones.
The factory default is level 1.
Switching music-on-hold on/off
If you are connected to an external user and are holding
an internal consultation or have activated the muting func-
tion, the external party will hear music during this time.
The music is switched ON in the factory setting.
To set the ringer tone, the base station ringer
must be switched on.
It is easier to distinguish between calls signaled
at the base station and the handset if different
ringer tones are set for each. The ringer tone can
also be set for the handset
(➔ page 34).
B # * 6 Start setting procedure. The selected ringer tone is
sounded. The set tone level is indicated on the display:
:
o
B Enter the applicable digit for the required ringer tone
(1 to 6) and save.
n 6 1
P f
N
b
(Example: tone level 1 is
set)
B # 1 Start the setting procedure.
o
Enter the four-digit system code (factory default “0000“)
(➔ page 19).
O 4 1 Start the setting procedure. The current setting
is displayed:
41 1 = switched on, 41 0 = switched off.
1 B Switch on music-on-hold (factory setting).
or
0
B Switch off music-on-hold.