Siemens Gigaset 2010 - Manual (Page 37)

External outgoing calls
27
KAP06.FM5 14.8.98 Gigaset 2010, UEB/engl.: A30852-X1100-E301-2-7619
Device control using dual-tone multifrequency signaling (DTMF)
If your telepone is connected to a line with dial pulsing
(DP), you can switch to dual-tone multifrequency signaling
(DTMF) once the connection has been set up.
Precondition: an external connection exists.
Dialing a DSS number from a locked handset
If the handset has been locked for external calls
(➔ page 46) and a DSS number is stored (➔ page 46),
it is possible to dial this direct number despite the lock.
Ending a call
B * Select and confirm.
When you have switched to DTMF, you can
switch between the two signaling methods dur-
ing the connection using the R signal key.
When the line is disconnected, the telephone
will automatically return to the original signaling
method.
Any digits or symbols that you enter after swit-
ching signaling methods are not stored in the
memory for redialing.
o
Press any key on the handset. The direct number is
dialed.
It is not possible to dial a DSS number from a
locked handset,
● if “unrestricted trunk access or outward re-
stricted trunk access“ is set (➔ page 45), or
● if the base station is locked
(➔ page 41).
Replace the handset in the loading unit. The line is dis-
connected.
or
a
Disconnect (on-hook key).