Siemens Gigaset 2010 - Manual (Page 27)

Operating modes
17
KAP04.FM5 14.8.98 Gigaset 2010, UEB/engl.: A30852-X1100-E301-2-7619
Operating in a telephone system
To be able to operate your Gigaset 2010 in a telephone
system, you must first
1. check the signaling method,
2. enter the exchange code,
3. enter the pause lengths after the exchange code.
Possible signaling method settings
The factory default setting for the signaling method is:
● DTMF/Flash
This may have to be changed to operate the device in tel-
ephone systems or in PSTNs in some countries.
Please also consult the instructions for use sup-
plied with your telephone system.
B
# 1
Start the setting procedure.
o
Enter the four-digit base code (factory default: “0000“)
(➔ page 19).
O
0 3 3 B Set dial pulsing (DP).
or
O 0 3 7 B dual-tone multifrequency signaling DTMF/Flash
(factory default).