Siemens Gigaset 2010 - Manual (Page 30)

Operating modes
20
KAP04.FM5 14.8.98 Gigaset 2010, UEB/engl.: A30852-X1100-E301-2-7619
Changing the system code
Changing the handset PIN
Resetting the base station to factory defaults
You can use this procedure to reset the following settings
to factory defaults:
● Signaling method (DTMF/flash 300 ms) ➔ page 16
● Pause length following exchange code ( 3 seconds)
➔
page 19
● Call allocation (collective call) ➔ page 51
The following stored data can be deleted:
● Exchange code
B
# 8 * Start setting procedure.
o
Enter the current system code (factory default "0000").
o
Enter the new four-digit system code. Note carefully the
number entered.
o Enter the new system code again to confirm.
B Store the setting.
B
8 9 Start setting procedure.
o
Enter the current PIN (factory default "0000").
o
Enter the new four-digit PIN. Note carefully the number
entered.
o Enter the new PIN again to confirm.
B Store the setting.
The stored system code (➔ page 19) is not de-
leted.
All registered handsets remain registered.
B
# 1 Start setting procedure.
o
Enter the four-digit system code (factory default: “0000“)
(➔ page 19).
O
2 5 0
B Reset the base station to the factory default.