Siemens Gigaset 2010 - Manual (Page 15)

Notes on operation
5
Kap03.fm5 18.11.98 Gigaset 2010, UEB/engl.: A30852-X1100-E301-3-7619
Notes on operation
Installing the base station
Installation site/installation area
● A 220/230V power socket must be located at the in-
stallation site.
● In order to avoid interference, the base station should
not be in the direct vicinity of other electronic equip-
ment such as HiFi, office or microwave equipment.
● Place the base station on a level, non-slip surface. The
device feet do not normally leave any unsightly marks.
However, due to the variety of varnishes and polish
used on furniture, the possibility of marks cannot be
entirely ruled out.
● Radio transmission between the base station and
handsets complies with the DECT standard. Gigaset
2010 thus observes all relevant regulations. However,
if there is interference to the picture or sound of your
satellite equipment, consult your specialist satellite
dealer.
● Depending on ambient conditions, the maximum ra-
dio range between the base station and the handset
is approx. 300 m outdoors, and approx. 50 m indoors.
If the range warning is activated for the handset
(➔ page 36), a signal will sound when you move out-
side the radio range.
Temperature/ambient conditions
● The base station is designed for operation in protect-
ed areas with a temperature range from +5 °C to +45°
C.
● The base station should not be installed in damp ar-
eas (such as bathrooms or laundry rooms), or close to
heat sources, or in direct sunlight.