Siemens sitrans LU01 User Manual

Page 2

Siemens Milltronics Process Instruments Inc. 2008

Safety Guidelines:

Warning notices must be observed to ensure personal safety as well as that of

others, and to protect the product and the connected equipment. These warning notices are
accompanied by a clarification of the level of caution to be observed.

Qualified Personnel:

This device/system may only be set up and operated in conjunction with this

manual. Qualified personnel are only authorized to install and operate this equipment in accordance with
established safety practices and standards.

Unit Repair and Excluded Liability:

•

The user is responsible for all changes and repairs made to the device by the user or the user’s
agent.

•

All new components are to be provided by Siemens Milltronics Process Instruments Inc.

•

Restrict repair to faulty components only.

•

Do not reuse faulty components.

Warning:

This product can only function properly and safely if it is correctly transported, stored,

installed, set up, operated, and maintained.

This product is intended for use in industrial areas. Operation of this equipment in a residential area
may cause interference to several frequency based communications.

Note:

Always use product in accordance with specifications.

Disclaimer of Liability

This document is available in bound version and in
electronic version. We encourage users to purchase
authorized bound manuals, or to view electronic versions
as designed and authored by Siemens Milltronics Process
Instruments Inc. Siemens Milltronics Process Instruments
Inc. will not be responsible for the contents of partial or
whole reproductions of either bound or electronic
versions.

While we have verified the contents of this
manual for agreement with the
instrumentation described, variations
remain possible. Thus we cannot
guarantee full agreement. The contents of
this manual are regularly reviewed and
corrections are included in subsequent
editions. We welcome all suggestions for
improvement.

Technical data subject to change.

MILLTRONICS®is a registered trademark of Siemens Milltronics Process Instruments Inc.

Contact SMPI Technical Publications

European Authorized Representative

at the following address:

Technical

Publications

Siemens

Siemens Milltronics Process Instruments Inc.

Industry Sector

1954 Technology Drive, P.O. Box 4225

76181 Karlsruhe

Peterborough, Ontario, Canada, K9J 7B1

Deutschland

Email: [email protected]

•

For a selection of Siemens Milltronics level measurement manuals, go to:
www. siemens.com/processautomation

. Under Process Instrumentation, select

Level

Measurement

and then go to the manual archive listed under the product family.

•

For a selection of Siemens Milltronics weighing manuals, go to:
www. siemens.com/processautomation

. Under Weighing Technology, select

Continuous

Weighing Systems

and then go to the manual archive listed under the product family.