Intel SERVER SYSTEM SR2500AL - Manual (Page 64)

42 Intel® Server System SR2500AL User’s Guide
Figure 31. Installing the Small Air Baffle
3. Install the server system cover. For instructions, see “Installing the Server System
Cover” .
4. Plug all peripheral devices and the AC power cable(s) into the server.
Removing and Installing the Large Air Baffle
Some installation processes will require that you remove the large air baffle that is placed
behind the hard drive bays, next to the fan module near the front of your server. The steps
below describe how to remove and then install the large air baffle. Use these steps only
when it is indicated as necessary for a component installation process.
Always operate your server system with the large air baffle in place. The large air baffle is
required for proper airflow within the server system.
Removing the Large Air Baffle
1. Observe the safety and ESD precautions at the beginning of this book. See “Safety
Information” .
2. Power down the server and unplug all peripheral devices and the AC power
cable(s).
3. Remove the server system cover. For instructions, see “Removing the System
Cover” .
4. Note how the cables are routed over and under the air baffle (if any). You will need
to re-route these cables.
TP02137