Intel SERVER SYSTEM SR2500AL - Manual (Page 113)

Intel® Server System SR2500AL User’s Guide 91
8. Install the server system cover. For instructions, see “Installing the Server System
Cover” .
9. (Optional) Install the front bezel. For instructions, see “Installing the Front Bezel” .
10. Plug all peripheral devices and the AC power cable(s) into the server.
Replacing a Fan Module
Replacing a Redundant Fan Module
1. Observe the safety and ESD precautions at the beginning of this book. See “Safety
Information” .
2. Power down the server and unplug all peripheral devices and the AC power
cable(s).
3. Remove the server system cover. For instructions, see “Removing the System
Cover” .
4. Remove the processor air duct. For instructions, see “Removing the Processor Air
Duct” .
5. Remove the PCI riser assembly. For instructions, see “Removing the PCI Riser
Assembly” .
6. Remove the optical drive cable if installed.
7. Remove the bridge board. For instructions, see
Figure 61 “Removing the Bridge
Board from the Server System” on page -71 .
8. Remove the large air baffle. For instructions, see “Removing the Large Air Baffle” .
9. Disconnect the fan cables from the mid-plane.