Intel SERVER SYSTEM SR2500AL - Manual (Page 104)

82 Intel® Server System SR2500AL User’s Guide
11. Connect all power cables to the server board.
12. Install memory. For instructions, see
“Installing DIMMs” .
13. Install processor(s). For instructions, see “Installing the Processor” .
14. Install the fan module assembly. For instructions, see “Replacing a Fan Module” .
15. Install the large air baffle. For instructions, see “Installing the Large Air Baffle” .
16. Install the bridge board. For instructions, see Figure 64 “Installing the Bridge
Board into the Server System” on page -73 .
17. Install the optical drive cable (optional).
18. Install the PCI riser assembly. For instructions, see
“Installing the PCI Riser
Assembly” .
19. Install the processor air duct. For instructions, see “Installing the Processor Air
Duct” .
20. Install the server system cover. For instructions, see “Installing the Server System
Cover” .
21. Plug all peripheral devices and the AC power cable(s) into the server.
Removing the Server Board
1. Observe the safety and ESD precautions at the beginning of this book. See “Safety
Information” .
2. Power down the server and unplug all peripheral devices and the AC power
cable(s).
3. Remove the server system cover. For instructions, see “Removing the System
Cover” .
4. Remove the processor air duct. For instructions, see “Removing the Processor Air
Duct” .
5. Remove the PCI riser assembly. For instructions, see “Removing the PCI Riser
Assembly” .
6. Remove the optical drive cable if installed.
7. Remove the bridge board. For instructions, see
Figure 61 “Removing the Bridge
Board from the Server System” on page -71 .
8. Remove the large air baffle. For instructions, see “Removing the Large Air Baffle” .
9. Remove the fan module assembly. For instructions, see “Replacing a Fan Module” .
10. Disconnect all cables from the server board.
11. Remove memory. For instructions, see
“Removing DIMMs” .
12. Remove the processor(s). For instructions, see “Removing a Processor” .