IBM PC Server/Enterprise Racks 42S - Manual (Page 107)

NetBAY 42 Enterprise Rack (Type 9308 Models 42P, 42X, 4SA, 4SB, 42S, 42E)
99
Installing a small server
Use the following general procedure to install a small server in your rack cabinet:
Figure 44. Installing a small server
1. See the server documentation for detailed installation and configuration
information.
2. Use the template and rack mounting instructions that come with your server to
determine where to install clip nuts.
3. Install the slide rails and cable-management arm that come with your server,
using the provided screws and clip nuts.
Note: If required, adjust the length of the slide rails to fit the depth of your rack
cabinet.
4. Lift the server and place it on the extended slide rails; then, attach the server to
the slide rails with the provided screws.
5. See your server documentation for information on how to connect power and
other device cables.
Server screws
Rear of rail
Front of rail
Rail adjustment
Cable-management arm