Intel iEi Motherboard A300 - Manual (Page 40)

A300 Motherboard
3.1 Anti-static Precautions
WARNING:
Failure to take ESD precautions during the installation of the A300 may
result in permanent damage to the A300 and severe injury to the user.
Electrostatic discharge (ESD) can cause serious damage to electronic components,
including the A300. Dry climates are especially susceptible to ESD. It is therefore critical
that whenever the A300, or any other electrical component is handled, the following
anti-static precautions are strictly adhered to.
Wear an anti-static wristband: - Wearing a simple anti-static wristband can
help to prevent ESD from damaging the board.
Self-grounding:- Before handling the board touch any grounded conducting
material. During the time the board is handled, frequently touch any
conducting materials that are connected to the ground.
Use an anti-static pad: When configuring the A300, place it on an antic-static
pad. This reduces the possibility of ESD damaging the A300.
Only handle the edges of the PCB:-: When handling the PCB, hold the PCB
by the edges.
3.2 Unpacking
3.2.1 Unpacking Precautions
When the A300 is unpacked, please do the following:
Follow the anti-static precautions outlined in Section 3.1.
Make sure the packing box is facing upwards so the A300 does not fall out of
the box.
Make sure all the components shown in Section 3.3 are present.
Page 25