MACKIE HDR24/96 - Manual (Page 71)

HDR 24/96
Store on the Remote 48 Store on the Remote 48
71
Autolocator Action Remote 48 Key Sequence
Store Locate Time to Locate n STORE LOCATE n
STORE STORE LOCATE n Store Tape Time to Locate n
or CTRL+STORE LOCATE n
Store Tape Time to Locate Time CAPTURE
Store Locate Time to Punch Length
• Value of Punch End Time = Punch Start Time +
Locate Time
STORE PUNCH
Store Locate Time to Loop Length
• Value of Loop End Time = Loop Start Time +
Locate Time
STORE LOOP
Store Locate Time to Pre-Roll STORE PRE ROLL
Store Locate Time to Cue n STORE ### ENTER
STORE STORE ### ENTER Store Tape Time to Cue n
or CTRL+STORE ### ENTER
Store Tape Time to New Cue
• Quick Cue Set !!!! (New Cue)
STORE CAPTURE
Store Locate Time to Cue in Cue List STORE
+/NEXT, -/PREV, or WHEEL
ENTER
STORE STORE ENTER
Store Tape Time to Displayed Cue
• Quick Cue Reset !!!! (Existing Cue Edit) or CTRL+STORE ENTER
Enter Time & Store w/o overwrite ######… STORE LOCATE n,
PRE ROLL, LOOP, or PUNCH
Enter Time & Store Cue w/o overwrite ######… Store ### ENTER
STORE STORE STORE
Cancel Store
STORE (+/NEXT, -/PREV, WHEEL,
and/or ###) STORE
Recalling Times on the Remote 48
Press the RECALL button to call up the value of stored time locations/values into the LOCATE
TIME display. The LED above the RECALL button blinks while Recall is in progress, and goes off
after Recall is executed or canceled. The following time values can be recalled:
Cues 0-999
Dedicated (numbered) Locates (LOC 1, LOC 2, LOC 3, LOC 4)
Pre-Roll Length
Loop Length
Punch Length
Last Play Start (PLAY button recall)
Each of the time values that have a dedicate button can be brought into LOCATE TIME display for
preview with a single press of that button. For a Cue, press the necessary number button(s) without
leading zeros. If you try to type in a non-existent Cue, then the LOCATE TIME displays dashes
(“- - -“) until a valid Cue or other stored value is selected. Press ENTER to commit the recalled value
to the Locate Time. Unlike the Store process, Recall must always be confirmed with the ENTER
button. This is because Recall offers a preview feature, where stored values can be viewed without
Technical Reference 71