Grizzly G0623X3 - Manual (Page 24)

-22-
Model G0623X/G0623X3 (Mfg. Since 5/12)
moving & placing
table saw cabinet
to lift and move the machine:
1. feed the lifting straps around the lifting bolts
on the back of the table and the sliding table
saw mounts on the front of the cabinet (see
figure 15). attach the ends of the lifting
straps to the forklift forks.
figure 15. lifting the table saw cabinet.
2. lift the table saw cabinet and move it to your
predetermined location.
3. remove the red lifting bolts from the back of
the table.
4. place a level on the cast iron table to level
the table saw cabinet side to side and front
to back. this will allow the table to slide
smoothly.
note: There are three options for leveling the
saw: 1) Place it on a mobile base (Grizzly
Model G7315Z) and use the mobile base
controls to level it, 2) shim under the cabinet,
and 3) thread bolts down into the nuts welded
on the stand corners (
Figure 16).
figure 16. hex bolt in stand corners for leveling;
the hex nut is used to secure bolt position.
do not lift the table saw any higher than
necessary to clear the floor. serious per-
sonal injury and damage to the machine
may occur if safe moving methods are not
followed.
this machine and its
components are heavy.
serious injury may occur
if safe moving methods
are not followed.
get help when lifting or
moving the machine and
its components. use a
forklift to reduce the
risk of a lifting strain or
crushing injury.
We strongly recommend using a forklift to move
this saw. this will greatly reduce the risk of a lift-
ing injury. if a forklift is not available, a minimum
of four strong people are required to move the
saw off the pallet. the saw can be "walked" off
the pallet, then moved into place with a dolly or
by sliding it.
We strongly recommend securing your
machine to the floor if it is hardwired to the
power source. consult with your electrician
to ensure compliance with local codes.