HP ProLiant DL100 Series Server DL100 Series - Manual (Page 32)

8. Connect the optical drive and power cable to the optical drive.
9. Connect the power connector to the power supply backplane.
10. Install the access panel.
11. Install the server into the rack.
Expansion board option
To install the component:
1. Power down the server (on page 13).
2. Remove the server from the rack (on page 13).
3. Remove the access panel (on page 14).
4. Disconnect all internal cables connected to any existing expansion boards.
5. Remove the PCI riser board assembly (on page 14).
Hardware options installation 32