HP ProLiant DL100 Series Server DL100 Series - Manual (Page 26)

CAUTION: To prevent improper cooling and thermal damage, do not operate the server
unless all bays are populated with either a component or a blank.
3. Remove the hard drive.
Installing a hot-plug hard drive
IMPORTANT: Hot-plug capability and drive LED support are only available when a supported
optional controller is installed in the server.
1. Power down the server (on page 13).
2. Remove the existing hard drive blank ("Removing a hard drive blank" on page 25).
3. Prepare the hard drive.
Hardware options installation 26