Running an internal test, Running an internal test -33 – HP SureStore 4215w User Manual
Page 86

3-32
Operating the Library
Running an Internal Test
Running an Internal Test
The library can run self-diagnostic tests. To run these tests, follow these steps:
CAUTION
Some diagnostic tests can place tape cartridges in unexpected locations. These tests
should be run only by authorized service personnel.
1. Verify that the drive status displays. If not, press
CANCEL
until it does.
2. Press
NEXT
until
ADMIN
*
appears in the display window, then press
ENTER
.
3. Enter the three-part numerical password (see “Entering the Administration
4.
INFO
*
displays. Press
NEXT
or
PREV
until
TEST
*
displays, then press
ENTER
.
5. Press
NEXT
until the name of the test to run displays, then press
ENTER
.
6.
NUM
LOOPS
#
displays, where the 1 is flashing. Press
NEXT
until the number of
test loops you wish to run displays, then press
ENTER
.
NOTE
Press
CANCEL
at any time to abort a test.
TEST
CANCEL
-
WAIT
displays while the
current test loop completes.
1 2
→
ADMIN *
→
TEST *