beautypg.com

Setting a new administration menu password, Setting a new administration menu password -10 – HP SureStore 4215w User Manual

Page 64

background image

3-10

Operating the Library

Setting a New Administration Menu Password

Setting a New Administration Menu Password

NOTE

Change the password to so that only authorized persons can access the library and
change operation settings. Do not forget the password. Only a service representative
can reset the password to the factory setting.

To set a new password:

1. Follow the steps on “Entering the Administration Menu Password” on page 3-9

to enter the existing password.

2. Press

NEXT

until

CONFIG

*

displays, then press

ENTER

.

3. Press

NEXT

or

PREV

until

NEW

PASSWORD

displays, then press

ENTER

.

4.

NEW

000-000-000

displays, and the first set of zeros flashes.

Press

NEXT

or

PREV

to display the new numbers you wish to assign the first part

of the password, then press

ENTER

.

5. The second set of zeros flashes.

Press

NEXT

or

PREV

to display the new numbers you wish to assign the second

part of the password, then press

ENTER

.

6. The last set of zeros flashes.

Press

NEXT

or

PREV

to display the new numbers you wish to assign the third part

of the password, then press

ENTER

.

7.

PASSWORD

CHANGED

displays. Press

CANCEL

three times to return to the drive

status (“ready” state).

NOTE

Save the new password to flash ROM by power cycling the library, which allows the
password to be recovered if the library is powered off for more than ten days.

Do not switch off power to the library until the SCSI bus is inactive. Removing
power from a SCSI peripheral when the bus is active can result in data loss and/or
indeterminate bus states. If the library is connected to a LAN, check with the system
administrator before shutting off power to the library.

1 2

ADMIN *

CONFIG * NEW PASSWORD