HP SureStore 4215w - Manual (Page 79)

3-25
Operating the Library
Setting Configuration Options
L
ibrary
O
perat
io
n
Setting Configuration Options
You can set certain options to customize the way the library operates. These options
are called configurations.
To change a configuration:
1. Verify that the drive status displays (if not, press CANCEL until it does).
2. Press NEXT until ADMIN * displays, then press ENTER .
3. Enter the three-part numerical password (see “Entering the Administration
Menu Password” on page 3-9).
4. INFO * displays. Press NEXT until CONFIG * displays, then press ENTER .
5. Press NEXT or PREV until the name of the configuration you wish to set displays,
then press ENTER . If the configuration has multiple settings, the current setting
flashes. Otherwise, the configuration option is set and a confirmation message
displays. (Configuration options are described on the following pages.)
If the current configuration setting is flashing, press NEXT or PREV until the
desired setting displays, then press ENTER . OPTION SAVED displays.
6. Press CANCEL to return to the drive status (“ready” state).
The table on the following page describes the available configurations.
1 2
→
ADMIN *
→
CONFIG *