Removing accessory boards, Connecting peripheral devices, Figure 3-23 – HP TC2120 User Manual

Page 47

Chapter 3

Installing and Configuring

11. Once the accessory board is installed, you may need to install software drivers.

The drivers for the new board are either part of your existing system software or included on a flexible
diskette or CD-ROM provided with the accessory board.

Removing Accessory Boards

Apply the same steps as the installation procedure in reverse. Replace the slot cover. See the preceding sections
for details.

Connecting Peripheral Devices

This section contains instructions for connecting the peripheral control devices, including the UPS and monitor,
to the hp server tc2120.

Figure 3-23. PCI Board Plastic Extension

NOTE

Ensure that you use a slot cover to seal the unused board slot
to prevent EMI interference. These slot covers make a better
metal-to-metal contact than previous slot cover designs.

NOTE

The two USB connectors are reserved for a keyboard and a
mouse.

Plastic

Extension