Accessory boards – HP TC2120 User Manual
Page 41
35
Chapter 3
Installing and Configuring
3. Connect the heat sink cooling fan power cable to the fan connector on the system board.
4. Replace the left side cover.
5. Replace the external cables and power cord.
6. Power on the server as described in
Chapter 1‚ Controls and Indicators
The BIOS automatically recognizes the new processor. Ensure that the latest version of BIOS is installed.
To learn which version of BIOS is currently installed, press F10 during startup, and then select Summary
from the list of options. To get the latest BIOS version for the hp server tc2120, connect to HP’s support
web site at:
http://www.hp.com/
Accessory Boards
The system board in the hp server tc2120 provides five PCI slots (P1 through P5), 64-bits at 33 MHz bus speed.
Four of the slots support 3.3 volt cards; the fifth (blue) slot supports a +5 volt card. Some PCI slots may come
with pre-installed boards. The SCSI model requires the first slot, (P1) for the SCSI controller board.
Figure 3-18. Replacing Heat Sink and Cooling Fan
CAUTION
Ensure that you connect the fan to the correct system board
connector. If necessary, see
in
.
Latch
Latch
Hook
Hook