HP TC2120 - Manual (Page 36)

30
Chapter 3 Installing and Configuring
7. Spread the two retaining latches on the slot and align the notches on the DIMM with the keys on the slot.
See Figure 3-13 .
8. Holding the DIMM at 90 degrees to the system board, press the DIMM fully into the slot until the retaining
latches close. See Figure 3-13 .
If the latches do not close, the DIMM is not inserted correctly.
9. Repeat Steps 7-8 to install the remaining DIMMs of your memory configuration.
Figure 3-13. DIMM to Slot Alignment
Figure 3-14. DIMM Insertion
Notches
DIMM Slot
Keys
Retaining
Latches
System Board
DIMM Slots
1 2 3 4