HP TC2120 - Manual (Page 103)

97
Chapter 7 Replacing Parts
You may need to lift the slot cover latch out of its retainer before lifting it out of the chassis.
7. Lift the accessory board up and away from the slot.
8. Place the accessory board and any cables in an anti-static container.
Replacing Accessory Boards
1. Read the documentation included with the accessory board and follow any special instructions.
2. If you are installing the accessory board into a new PCI slot, continue with Step 3.
If the accessory board is a replacement for a defective board, skip to Step 5.
3. Remove the slot cover latch by:
a. Lifting up on the tab of slot cover latch with your finger.
b. Raise the slot cover latch up away from the slot covers.
c. Remove it from the chassis and keep it for reassembly later.
You may need to lift the slot cover latch out of its retainer before lifting it out of the chassis to remove the
slot cover latch.
4. Select the desired accessory slot cover, slide the top of the slot cover away from the chassis, and then lift it
up and out of the chassis as shown in the following illustration.
5. Slide the accessory board into the desired PCI slot and then press down to seat the board.
Figure 7-14. Removing Slot Cover Latch
Slot Cover
Latch
Latch
Retainer
1
2
3