HP AD117-9003A-ED3 - Manual (Page 85)

Figure 4-55 Sliding the System Board into the Chassis
4. Install the system board mounting screw. See Figure 4-56 .
5. Connect all cables to their appropriate connectors on the system board.
6. Install the six rear backplane system board mounting screws.
Figure 4-56 Installing the Rear Panel Mounting Screws
7. If the server has an iLO MP, install it now. See “Replacing the MP Card” (page 79) .
8. Replace the power connectors in their slots on the back of the server and install the power
connector mounting screws. See
Figure 4-57 .
Removing and Replacing Internal Components 85