HP AD117-9003A-ED3 - Manual (Page 52)

Figure 4-16 Releasing the Disk Drive
4. Pull outward on the release lever to remove the drive from the server. See Figure 4-17 .
Figure 4-17 Removing the Disk Drive
Replacing a Hard Drive
To install or replace a hard drive:
1. Insert the hard drive into the drive bay from which you removed the drive and push inward
on the release lever until the drive no long slides forward. You must leave the release lever
in the open position when you push the drive into the server.
2. Release the lock on the drive being installed and swing the drive ejection handle to the open
position.
3. Slide the hard drive into the slot until it is nearly seated.
52 Removing and Replacing Components