HP AD117-9003A-ED3 - Manual (Page 65)

Figure 4-30 Unlocking the Processor Module Locking Mechanism
9. Lift the processor up and out of the chassis. Place the processor module into an anti-static
container.
Replacing a Processor
CAUTION: Do not modify the settings of the DIP switches located on the system board. These
switches are for factory use. Failure to observe this caution will result in server failure.
1. Power off the server and disconnect all cables. See “Powering Off the Server” (page 37) .
2. Remove the top metal cover. See “Removing and Replacing the Top Metal Cover” (page 43) .
3. If you are replacing a processor module, remove the old processor as described in “Removing
a Processor” (page 63) .
4. Verify the ZIF socket lock is unlocked. The thicker post on the locking mechanism must be
pointed toward the unlock symbol on the ZIF socket.
Figure 4-33 shows the socket unlocked.
Removing and Replacing Internal Components 65