HP AD117-9003A-ED3 - Manual (Page 80)

4. Lift up on the battery and push on the back of it with a flat-head screwdriver to remove the
battery from its holder. See
Figure 4-48 .
CAUTION: Only lift the battery high enough to clear the holder. Excessive stress on the
battery holder retaining clip can damage the clip.
Figure 4-48 Removing the MP Card Battery
Replacing the MP Card Battery
1. Lift up on the battery holder retaining clip with a flat-head screwdriver and slide the battery
into the holder. The positive (+) terminal of the battery faces up.
CAUTION: Only lift the battery high enough to clear the holder. Excessive stress on the
battery holder retaining clip can damage the clip.
2. Perform all of the steps described in the procedure for “Removing and Replacing the MP
Card” (page 77)
3. Verify the battery replacement by using the utilities identified in Appendix C (page 141) . To
verify operation, use the iLO MP commands.
80 Removing and Replacing Components