Server components, Processor, Memory – HP AD117-9003A-ED3 User Manual
Page 20: Pci riser, Internal core i/o, External core i/o, Server dimensions, Table 1-1
Table 1-1 Server Dimensions
Value
Dimensions
2U
Rack units
8.6 cm (3.4 in.)
Height
48.3 cm (19.0 in.)
Width
67.9 cm (26.8 in.)
Depth
17.5 kg (38.6 lb.)
22.2 kg (49.0 lb.)
Weight
• Minimum
• Maximum
Server Components
The server consists of the following components:
Processor
•
1.4 GHz/12 MB L3 cache dual-core processor
•
1.6 GHz/18 MB L3 cache dual-core processor
Memory
•
12 memory DIMM slots
•
256 MB, 512 MB, 1 GB, 2 GB, and 4 GB standard 184 pins 2.5 V DDR1, CL2, registered, ECC
•
133 MHz memory bus frequency, 266 M transfers/s data, 8.5 Gb/s peak data bandwidth
•
Minimum memory size of 1 GB with four 256 MB DIMMs
•
Maximum memory size of 32 GB with eight 4 GB DIMMs
•
Upgrades must be made by quads of DIMMs
•
DIMMs loaded by quads enable interleaved mode and chip spare
PCI Riser
•
Four independent PCI-X 133 MHz 64 bit, 3.3 V, 15 W slots. There is no 5 V card or hot-plug
support.
NOTE:
Some 25 W cards are supported. See the Server I/O Slot Matrix on the HP website
For more information regarding specific I/O cards, see
Internal Core I/O
•
Dual channel SCSI U320 interface, two internal 68-pin connectors, one 68-pin external
connector
•
Three internal SCSI drive 80-pin type connectors that provide drive electrical hot-plug
capability
•
One internal IDE connector for a slim-line optical device (CD and DVD)
External Core I/O
•
One SCSI U320 68 pin connector
•
Two 10/100/1000Base-T Ethernet LAN connectors for twisted-pair cable
•
Four USB 2.0 ports
•
Two general purpose or 9-pin serial ports, 16550 compatible
20
Introduction